< TOP

Honeycomb Cutting Table:

Purpose:
Supports materials being laser cut and provides some vacuum hold down.
Advantage:
Minimizes burning of the back side of materials being cut all the way through by supporting materials above the reflective work table in the machine. The honeycomb design supports even small cut parts. The cutting table is designed to draw air through it to remove smoke and cutting vapors as they are generated which aids in keeping the cut parts and the machine cleaner. The table has ruler guides similar to the work table it is installed onto to aid in positioning materials.
Compatibility:
All M, V and X laser platforms.
Common Uses:
Acrylic, wood, and paper cutting.

< TOP

High Torque Rotary Fixture:

Purpose:
The High Torque Rotary Fixture was developed to allow laser processing around cylindrical surfaces. It holds the part between two cones that adapt to a variety of common shapes. It also can accommodate tapered items because it allows raising one end of the fixture. The fixture is computer controlled and can engrave an entire 360 degrees around an object or more if overlap is needed.
Advantage:
Ability to process cylindrical objects
Compatibility:
All M, V and X laser platforms.
Working Range:
Items up to 8 inches in diameter and up to 16 inches long. Installation: Less than 30 seconds. All Compatible systems are shipped from the factory rotary ready.
Common Uses:
Glassware, sporting goods, mugs and most cylindrical objects.

< TOP

Red Laser Pointer:

Purpose:
Visible red beam material positioning tool.
Advantage:
Simplifies and speeds setup by verifying exact position of odd shaped items on the work table. The position on the work table that the beam points to is displayed in X-Y coordinates to allow proper job setup. The beam can also be turned on in a simulated machine run to point to where the processing laser beam will be during an actual production run.
Compatibility:
Standard on all laser platforms.
Common Uses:
Most critical positioning on the table. Recommended for all machines.

< TOP

Coaxial Air Assist with Optics Protection
(Non-Computer Controlled):

Purpose:
Suppresses flaming and assists with optics protection.
Advantage:
The Non-Computer controlled air assist Air Assist provides the same lens and mirror protection and flame suppression (using a nozzle) as the more sophisticated Computer Controlled Air Assist but with a single gas and no computer control. Turning the compressor pump or gas supply on lets air or gas flow. Turning the compressor pump or gas supply off stops the air or gas flow.
Compatibility:
All M, V & X laser platforms. Requires an external air supply. The External Compressor Unit for Air Assist is highly recommended. Any air or gas supply not provided by ULS must have a regulator set to no higher than 60 PSI. Filtered air from a compressor using oil is not acceptable. Air must be oil free, dried and filtered.
Installation:
Must be factory installed.
Common Uses:
Higher power engraving or cutting and any rubber engraving.

< TOP

Dual Head Option:

Purpose:
The Dual Head Option allows laser processing of two identical jobs at the same time. It does this by splitting the work area into two identical work areas and the beam into two beams. Because splitting the beam reduces each beams power by approximately 50%, it is usually necessary to reduce processing speed.
Advantage:
Production rate increases from 0-100% depending on application. Advantages typically increase with higher power and larger engraving areas.
Compatibility:
Professional Series (M360, X & V platforms)
Installation:
Under one minute.
Common Uses:
High volume production of large identical items.